Ellison Sales Gives You Choices – At Ellison Sales we specialize in Hogs and offer you the choice of As-Is from our large nationwide inventory or Reconditioned with a Warranty. And you can rest assured that when Dan the Hog Man says it’s reconditioned, it’s much more than new paint. So if you need a replacement hog or if you’re adding mulch or grinding to your operation, your first call should be to Ellison Sales toll-free at 1-888-244-0161 to insure you get the right system and components to create a profitable product. From bark mulch, sawmill waste, pallet recycling to tire and other material reduction you only need one name – Ellison Sales.

In addition, Ellison offers material handling systems, related electrical and more. Check out our current inventory below.


Ellison 51XLKC Screen

Hog screen with 3" holes, baffles and hardfacing

Jeffrey Hog Hammers

ESCO 4103226 "THOR" 50# (actual 47.4#) hammer assemblies for Jeffrey 42-series B3 hogs (42x24, 42x36, 42x48, 42x66). Quantity is 18 pcs. Hammers are 3.5" thick, with a 2.56" pin hole and 11.0" swing length. The 3.5"-wide "THOR" tip is a part# 4087565, which can be used on Jeffrey 36-series B3 hogs, Jeffrey 50-series (fine grind) hogs, Lamb 36/HX6-series and 42/H7-series hogs, Stringer 5440 hogs, Salem SR30/SR40/SR50 hogs, Progress #27/36/45 hogs. (We did have these hammer assemblies listed as just for a Lamb hog.)

Eurohansa EUR-40

30hp main motor, 2hp hydraulic motor, 480VAC

Lamb 24 x 33

Lamb 24x33 Swinghammer hog pkg, Hog mounted on a 9’ long subbase with a Toshiba 150hp 1770rpm 230/460VAC motor direct-coupled to it and guard cover, with a 6-foot long wire (3 “heavy” plus one smaller ground) & conduit connected to the motor, that had been from the motor to the switch on the base. Dimensions are 9’ long x 4’ wide x 4’ high. Hog bearings are still fairly new. Steel platform with a 3-fuse disconnect switch still on it, with wire and conduit (length?) that fed to the switch. Dimensions are 12’ long x 9’ wide (same as the hog subbase length) x 4’ high. Upper infeed hopper. Dimensions are 12’ high x 44” wide x 102” front-to-back. One spare set of hammers that need to be rebuilt, and (7) spare hammer pins, still new and wrapped in paper. The infeed conveyor in the pictures is not included.

Montgomery Industries 34HD50

200 HP motor with V-belt

West Salem 3456BH

Motor shown in the picture is no longer available.

West Salem 2822BH

West Salem 2822BH, 150HP TECO Motor

Montgomery Industries 50PM-HZF

Montgomery 50PM-HZF

Williams Pulverizer

52"x29" opening,200hp 1200rpm motor. No grate.

Jacobson 42315 XLT

Jacobson / Carter Day XLT Full Circle Hammermill 125HP Reliance XE Energy Efficient Extra Tough direct drive motor 460 volts 1785 RPM